Outputting Card Data in Hex

2 min. readlast update: 11.11.2026
 

TECHNICAL GUIDE

Outputting Card Data in Hex

Using the rf IDEAS® Configuration Utility

This guide shows how to set an rf IDEAS® reader to send card data in hex format.

Configuration Steps

Step 1  Download and Install the Configuration Utility

Open the rf IDEAS® Configuration Utility download page for Windows at the link below. You must accept the End-User License Agreement (EULA) before the download begins.

rf IDEAS Configuration Utility for Windows (latest)

Save the file to the Windows PC, extract it if needed, and run the installer. If it does not open, check that you have administrator rights.

Step 2  Connect to the Reader

Connect the reader to the PC by USB and launch the utility. Select Connect, then confirm the Status bar shows a connected status. If it does not connect, check the cable and try another USB port.

Step 3  Open the Data Format Settings

Click the Format button on the left side of the utility, then select the Data Format section.

Step 4  Check Send ID as Hex

Locate the Send ID as hexadecimal number check box under Send ID and check it so the card ID is sent as hex characters. If Send ID is unchecked, check it and define the ID field bit count for your card format before you continue. Leave the box unchecked only when your software expects decimal output.

Title: Data Format tab - Description: Data Format tab showing the Send ID as hexadecimal number check box

Step 5  Save the Changes with WRITE

Select the WRITE button to save the changes to the reader. Wait for the Status bar to confirm the write before you disconnect the reader.

Step 6  Test the Output

Open the Home tab and locate the Output Test Area. Present a card to the reader. The hex value should appear in the test area.

 

Was this article helpful?