Firmware flash upgrade Tech guide

2 min. readlast update: 11.10.2026

Loading WNCxxx / WN5xxx Firmware into pcProx Plus v2

Using the RFID_BL_Dist_4050.exe Firmware Flash Utility

 

 

Prerequisites

Hardware

pcProx Plus v2 reader connected to the PC via USB

Software

RFID_BL_Dist_4050.exe Firmware Flash Utility installed and open

Files

WNC/WN5 firmware hex file from the firmware upgrade package, located in an accessible folder

 

Flash Procedure

1

Select Product

In the Flash Utility, choose "pcProx" from the Product dropdown.

2

Connect via USB

Click "USB Connect" to establish communication with the pcProx Plus v2.

3

Select Firmware File

Click "Select a file to download…" and navigate to the firmware upgrade package folder.

Select the WNC/WN5 firmware hex file and click Open.

 

Note: The firmware file name may vary depending on the upgrade package version.

4

Open the File

Click Open to load the firmware file into the utility.

5

Program the Device

Click "Program Device" to begin flashing.

 

CAUTION: This process may take several minutes. The application may appear unresponsive

and "Not Responding" may display in the title bar. Do not unplug the reader during this process.

6

Confirm Completion

Flashing is complete when the reader power-cycles, [Not Connected] appears in the title bar,

and the Lines and Lines Sent counters display the same value.

 

Figure 1 — Steps 1–4: Select product, connect USB, select firmware file, and click Open

Figure 2 — Step 5: Click Program Device to begin flashing

Figure 3 — Step 6: [Not Connected] in title bar and matching Lines / Lines Sent confirm completion

⚠ CAUTION: Do not unplug the reader while firmware is being uploaded. Interrupting the process may corrupt the device.

 

✔ Finished: The reader is ready to be configured. Open pcProxConfig.exe to complete device configuration.

 

For further assistance, contact rf IDEAS® support or visit www.rfideas.com.

Trust begins here.™

Was this article helpful?