HP MFP using pcSwipe with Papercut - USB device not supported error
Using pcSwipe in a Papercut environment and receiving the error
“Attached USB device will not be used because it is not supported”
Model (MS3-00M1AKU) mag stripe reader using the config key ext-device.hp-oxpd.additional-card-readers.vid-pid.hex needs to be 0x0c27:0x1000 otherwise they will get the reader not supported error message, IF you neglect to add the “0x” in the VID/PID.
See this example:
Try the following device config key, this would be accessed from the
PaperCut admin dashboard under Devices > Select a device > Config Editor