Ethernet 241™ Single IP Mode

2 min. readlast update: 11.10.2026

Title: rf IDEAS logo - Description: rf IDEAS logo

Technical Guide

Ethernet 241™ Single IP Mode

Set up single IP operation and confirm card reads

The Ethernet 241™ runs in one of two modes. Standard mode keeps the 241 and printer as separate network devices. Single IP mode combines them into one device.

Operating modes

 

Standard mode

Single IP mode

Network identity

241 and printer appear as separate devices, each with its own MAC and IP.

241 clones the printer’s MAC and IP. Both appear as one device.

Setup steps

Step

Action

1. Connect

Connect to the web interface by putting the E241 IP in a browser.

2. Enable

IP tab on the 241 web page: select Single IP.

Or on the command line:

set single_ip enabled

Takes effect after a power cycle or reboot. To revert, use: $set single_ip disabled

3. Change ports

Set the 241 HTTP and HTTPS ports to values that suit your network so the printer web page stays reachable. Changes apply immediately.

4. Set server

Server tab: Data Server URL as https://<server-address> (use http:// if not encrypted).

Check Init/Data Server ports to match your Print server.

5. Verify

Swipe a card and check the Log tab for a line like:

DEBUG Reader 1 Card Presented: Dec Id=33459, Hex Id=7082B3, Bits=24

Troubleshooting

Symptom

Check

LED flashes red 30 seconds after power-up

No printer detected. Connect the printer; Single IP resumes.

LED blinks green after 30 seconds

241 fell back to default DHCP/Static addressing because no printer was found at power-up. Reconnect the printer to return to Single IP mode.

Cards read but no data reaches the server

Check the Data Server URL and http/https prefix.

Related Article, Changing Web Interface Port:

https://knowledgebase.rfideas.com/changing-web-interface-port-on-ethernet-241/

For further assistance, contact rf IDEAS® support or visit www.rfideas.com.

 

Was this article helpful?